Saturday, June 11, 2011

first useful print

this is just a few pics of one of my first useful prints.

here is my solderless bredboard holder 




here you can see the bare connection rails.
i made that to hold the solderless breadboard that its tape came off from.

i have found that i have a backlash issue, and i ordered a new pully for it today, so i hope it will be here early next week  i hope. so i hope that will make for much better prints too. i will try again to print another pully, but with the back lash some of the teeth just never seem to come out right, and i am back to the same problem.

No comments:

Post a Comment